There are a couple of areas where it is important to know if water is flowing (or not flowing). On the FPB 64 these include raw water feed to the engine and through the damage control pump. The light grey device in the upper left hand corner is a vane type flow meter made by Aqua Alarm. A vane senses flow or lack thereof and triggers a micro switch that can be wired normally open or closed.
On the FPB 64 both of these alarms show up on the Maretron NMEA 2000 displays.
Posted by Steve Dashew (February 5, 2010)
February 5th, 2010 at 5:45 pm
“The light grey device in the upper right hand corner…”
Did this photo get reversed? Because the only light grey device I see is in the upper left hand corner.
February 6th, 2010 at 6:16 pm
Hi Biff:
Bad day for posts! Second typo in this one. It is the center LEFT device to which we are referring.
February 6th, 2010 at 11:15 am
I checked out the US Aqua Signal website and saw nothing but lighting products. Is that flow meter made by Aqua Alarm instead? Any information would be appreciated. -drew
February 6th, 2010 at 6:14 pm
Hi Drew:
Typo! It should be Aquaalarm – https://www.aqualarm.net/store/comersus_listItems.asp?idCategory=67
February 6th, 2010 at 6:57 pm
Have you used these alarms on your other boats? I always worried slightly that they could be a failure point from the standpoint of clogging or some such. Is there no way that they can stick and block flow themselves? Glad to hear that you are using them as it is quite a recommendation.
February 6th, 2010 at 8:27 pm
Drew:
Have used them on a number of our yachts going back ten years or so. Yes, they do introduce a potential leak point, but the advantage, in our opinion, outweighs the risk. And if a leak were to occur we assume we could deal with it.