Basement Systems

FPB-64-1-Basemen-systems-100

The basement area under the great room on the FPB Series is key to the entire systems approach, not to mention storage. It allows us to position gear so it is easy to inspect and maintain, while providing a huge amount of bulk space.

We will start this tour in the forward port corner looking at half of the ship’s battery bank. Note that the fuel tank tops which provide the basement floor are above the waterline with batteries being a further 800m/32″ above this.

FPB-64-1-Basemen-systems-101

Same location, looking to starboard at the three 2500 watt inverters.

FPB-64-1-Basemen-systems-102

Moving across and looking back to port at the batteries and electronics installation.

FPB-64-1-Basemen-systems-103

Having easy access for installation and maintenance of electronics is not always possible. The FPBs have been designed from the beginning with ease of electronics installation and maintenance in mind.

FPB-64-1-Basemen-systems-104

There are a lot of black boxes and wiring to be dealt with and hiding it away where it is hard to get at makes no sense.

FPB-64-1-Basemen-systems-105

Autopilot controllers (right), stabilizer controller (center), Nav Net 3D, AIS, sonar, and SSB black boxes all reside here.

FPB-64-1-Basemen-systems-106

Looking to starboard from center, batteries to the left. The hatch is to the sealed coffer dam in which the stabilizer mechanism resides.

FPB-64-1-Basemen-systems-107

The light load 115V inverter opposite the heavy load bank of three.

FPB-64-1-Basemen-systems-108

High load DC fusing, remote control solenoids, and connection point (left) for bridge electrical panel.FPB-64-1-Basemen-systems-109

A closer look over the coffer dam lid at the wiring (batteries are to your left).

FPB-64-1-Basemen-systems-110

Turning around now and looking back across the boat to port. The sonar black boxes are directly opposite.

FPB-64-1-Basemen-systems-111

Same area, now looking at the center basement divider bulkhead.

 

FPB-64-1-Basemen-systems-112

We are in the aft port corner now, under the galley. Heater manifold is at bottom right with the fuel manifold above. Trash compactor is opposite.

FPB-64-1-Basemen-systems-113

You are looking up here, behind the galley furniture (you can stand here). The air conditioners are mounted just below the deck with access to their inlet screens and gauge ports for maintenance.

FPB-64-1-Basemen-systems-114

The basement freezer, trash compactor, and fuel manifold are accessed from hatches in the galley sole.

FPB-64-1-Basemen-systems-115

Looking outboard into the port aft corner. The through hull is the galley discharge, above the waterline of course.

FPB-64-1-Basemen-systems-116

Port side air conditioner circulation pumps.

FPB-64-1-Basemen-systems-117

The view across the boat to starboard.

FPB-64-1-Basemen-systems-118

Starboard aft corner with the shore power isolation transformer in the right hand (aft) corner.

FPB-64-1-Basemen-systems-119

Fresh water system with one of two pumps shown. Valves on the right are for the basement bilge pump.


Posted by Steve Dashew  (March 29, 2010)




4 Responses to “Basement Systems”

  1. Alan Says:

    Hi Steve, are the fresh water pumps fixed speed or variable speed type? Did you go for Shurflo?
    regards
    Alan


  2. Steve Dashew Says:

    Hi Alan:

    Shurflo supplied the pumps.


  3. Max Says:

    Steve,
    It’d be real nice to see one of these photos with a human in it to get a sense of scale. What is the headroom height in the basement?


  4. Steve Dashew Says:

    Hi Max:
    Clearance from tank tops to underside of cabin sole above is 34″/850 mm (from memory).